Does anyone know of or Remember the old video where he was in Germany and was filling a rental car with diesel and talking about winter diesel vs summer and how they take the wax out of the winter diesel and your getting ripped off per litre(less btu), and I think it was the same video when he went to a German mechanical museum.

I’m going to Germany in a few months and really want to checkout that museum. I’ve looked though all his old videos without watching them all again and can’t find it. I hope this isn’t the Mandela effect or maybe he took the vid down? Anybody can help me in this search? Or remember that video?

Old school ave.

Tried posting once, and the post was removed by an auto-moderator, which is fun.

So, got the 25mm utility blade, cleaned up all the parts, and awaited the Olfa blades before I began final assembly. I've been following the video guide, and it seems like the screws are too small for the base plate; I can't thread them through the bottom to act as guides for the rest of assembly. Has anyone else run into this issue? Any fixes, or am I screwed (no pun intended) until I can get a replacement?

Just as the title says. Sanded and cleaned up all of the components, waiting until the Olfa blades arrived, and I'm attempting assembly as per the video guide. The holes on the basal platten (base plate) seem far too small to fit the screws, to the point where I can't use screws coming through the bottom as a guide for the rest of the assembly. Anyone else run into this issue?

The blade rattles pretty bad and the safety release in the back of the knife will not hold the blade in place. Is this an error on my part, or a design issue?

It used to be entertaining machining & fabrication tips and tricks, and tool review/BOLTR.

Realised I hadn't watched a video in years, and found that it's like a bad parody of what I remember.

It went from "thumb detectors", "schmoo", and "keep your dick in a vice", to absolute ramblings with zero substance in the space of a few years by the looks of it.

Good to see AvE back on the tube. I miss the boltr videos though. Even did a tribute video for his poor camera.

Focus you Fark

This may be a stupid question but does the 18mm utility knife use a titanium blade guard or is it SS?

What size screws are used for the 18 and 25mm knives? I’ve got some fat ass sausages and lost a few in the carpet.

I am working on a project at work where we want to put a GoPro inside one of our CNC lathes. There is a heavy coolant flush during operation, and in searching for a more cost effective alternative to commercial spinner lenses, I came across this video and would like to try replicating the idea. He mentions putting the STL file out somewhere, but I haven't had any luck in finding it. Short of reverse engineering from the video, does anyone know if the STL file exists and where I can get it from? Thanks