Would this peeling cause an issue?

[u/mr_choc30]

Gen5detect Stick Vacuum

[u/AutoModerator]

Have you tried contacting Dyson support yet?
US: [866-693-9766](tel:8666939766) | [UK: 0800-298-0298](08002980298) | CA: [1-877-397-6622](8773976622) | AU: [1800 239 766](1800239766) | NZ: [0800 397 667](0800397667)

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[u/Worried_Patience_117]

Poor build quality 😅

[u/JoseAmador95]

https://www.reddit.com/r/dyson/s/bUvakgzwhW

[u/mr_choc30 → u/JoseAmador95]

Thank you, this is the response I got from them.

[u/Flat_Direction1452]

Over time yes, that's a seal which can result in poor cyclone performance and/or suction leaking when they get to that state. I'd contact dyson for a replacement.

[u/SpreadIll]

The fact that it’s slapped together in Malaysia

[u/okazar]

It's already an issue. Put a kleenex against it, if it pulls you have loss of power. Thats going to peel off eventually. Warranty now, don't wait

[u/ocean128b]

Dyson isn't like it used to be. Not even close. I bought a $400 hair dryer and while I do like it it's not super fantastic or anything. I bought one on ebay first and it was fake so I went directly to dyson and there was some irritating back and forth but ultimately I got my dryer and for a better price. ($340)

[u/Environmental-Lion82]

Mine was the same from new. I got a plastic card and fed all of it back into the groove. Its not come out since then and that was 4 years ago