r/turning • u/ittthelp • 2d ago

newbie Blanks and chucks questions

Just a few questions, I'm new to turning. I've ordered this Nova chuck set. I want to make small boxes like this, this seems like an easy method.

  • Could I use 2x2 blanks like these with 2" jaws or do you have to use 3x3 blanks? I don't know if the 2" jaws will be able to close enough to hold a tenon after rounding a 2x2.

  • Could I use the pin jaws to hold 2x2 blanks if the 2" jaws don't work? I can't tell if the interior of the pin jaws are meant to hold a tenon or not and I'm not sure how far they can expand. I don't want to cut mortises into the pieces I make.

I think the 2" jaws will work, this page says "Tenon Diameter: Min Cylinder 45mm (1 1/14), Max Cylinder 65mm (2 9/19). Min Square 40mm (1 9/16), Max Square 50mm (2”)." Does that mean it can hold onto tenons between 1 1/14" and 2 9/19" in diameter?

5 Upvotes

100% Upvoted

10 comments sorted by

View all comments

•

u/AutoModerator 2d ago

Thanks for your submission. If your question is about getting started in woodturning, which chuck to buy, which tools to buy, or for an opinion of a lathe you found for sale somewhere like Craigslist or Facebook Marketplace please take a few minutes check the wiki; many of the most commonly asked questions are already answered there!

http://www.reddit.com/r/turning/wiki/index

Thanks!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.