That is all I use. About 30 devices connected to it.

The out door unit

“Flexihopper” very much obsolete TDMA microwave. 34Mbps over the air from memory. This one looks to have a 4 x 2Mbps PDH interface card installed on the left. The 10baset port was for management not traffic. The other Ethernet ports are RS422 management ports. The coax connectors on the right are for connecting the out door unit.

Try the repair cafe or something similar near you?

https://www.repaircafe.org/en/

I have one of those gimmicky “remove before flight” key rings that I attach to my bag when I put tools in there. Haven’t lost a tool since…

Does it have a degauss function? Something next to it may be producing/ have a permanent magnetic field that is deflecting the beam?

Cone spanner?

Micrology subscription. Postie drops off a kilo every fortnight. :)

The big one in the middle labeled ‘Main’.

My X1 Nano gen2 exhibited similar behaviour. Setting it to ‘linux S3’ in the Bios sleep settings solved it for me.

Thank you

I do.

👍

Are you using amdgpu drivers? ‘lsmod | grep amdgpu’

Is your system up to date?

Save on etching chemicals?

Guys grooming

Micrology in Osborne Park. They also have a subscription service 👍

All sharp is a mobile sharpening service.

Scrap off a little solder mask on the traces going to the damaged (missing) pads and use fine wire to solder to the traces and bridge them to the switch leads.

It looks like it is still repairable. You will definitely need finer tools than what you have. Maybe your friend with the solder wick?

Adapters are also a good way to stop/ slow the expensive bits from wearing out. I would buy an antenna with a threaded connection so you get a solid connection with your BNC adapter.

That looks set up to solder wires directly to the board. Pass the wire through the larger hole from the back. Loop it back and solder through the smaller hole. This is done to provide strain relief on the wires.

Yes, the Nano X can store Helium.

Starter is part of the housing. Some are replaceable…. Usually if the bulb lights then it is fine.